: After flashing, remove the BOOT0 jumper. When you power the device with a USB stick containing the firmware update files, the installer will finalize the HxC Bootloader installation. Why Use HxC Firmware?
:102700000C0112007C120020F40800D0FA0A00D0AA
Based on the filename Hxc-fw-installer.hex , this guide pertains to the (specifically the SD Card HxC Floppy Emulator hardware). This file is a firmware update utility used to flash the internal memory of the emulator device.
To use the hxc-fw-installer.hex file, you typically need the following:
signal to VCC (usually by placing a jumper or temporary wire on the "J3" header) to put the chip into programming mode. : Use tools like the STM32 CubeProgrammer , or the official HxC SecSerialBridge software to upload the hxc_fw_installer.hex file to the device. Finalization