Hager Controls Bp 10140 Manual [repack] Now

: Use the small "pins" or tabs around the dial. Pushing tabs in (or towards one side) typically sets the "ON" state, while leaving them out (or towards the other side) is "OFF".

If the label is worn, look for the common (C) and normally open (NO) terminals. For most standard "start" or "access" signals, you will wire between C and NO. hager controls bp 10140 manual

If your device is a standard timer (one of the most common products bearing the BP 10140 address), here is how to use it based on standard Hager documentation: 1. Wiring and Installation : Use the small "pins" or tabs around the dial